AmericanLongRifles Forums
General discussion => Gun Building => Topic started by: Nhgrants on June 15, 2019, 02:10:39 PM
-
My plan was to appy diluted cherry to my cherry stock and then apply diluted american walnut over it.
I plan to test this with scraps first. Do I first put denatured alcohol in a cup and then add the stain to it by
Just drops or much more like teaspoons? I guess I asking is it just a very little LMF stain added to the denatured alcohol ?
Thanks
-
The few times I used LMF I used it straight out of the can.
-
The best way is to mix it proportionally, I.e. One to one, one to two, etc. That way you can duplicate the results on your test strips.
Otherwise, it's just a guess.
-
I always apply full strength because it tends to fade over time.
-
LMF stains are used w/o diluting, except the red.....made the mistake of using it full strength and it was the brightest red I could imagine and was very difficult to tone down. Never again......Fred
-
except the red.....made the mistake of using it full strength and it was the brightest red I could imagine and was very difficult to tone down.
You tone it down by soaking a pad with alcohol and rubbing. It will pull some of the stain out into the pad. This is also useful if you have a mottled finish and need to even it out.
-
I did just that numerous times and the red color was very stubborn so finally applied some dark brown LMF, rubbed that out w/ alcohol and it did the job......Fred