Author Topic: rebarrelling a TVM  (Read 3634 times)

sloe bear

  • Guest
rebarrelling a TVM
« on: April 20, 2013, 09:28:14 PM »
I have a fairly new Virginia style %8 cal from TVM, I don't use it much and was thinking that maybe it would be of more use if it was in a smooth bore rifle , what do you all think about changing the barre ll to a colerain 58 smooth, I think it would make me usable gun.
 or should i start looking for a different gun? any thoughts on this will be taken under advisement. thanks

Offline Mike Brooks

  • Hero Member
  • *****
  • Posts: 13235
    • Mike Brooks Gunmaker
Re: rebarrelling a TVM
« Reply #1 on: April 21, 2013, 03:00:51 AM »
I'd have Hoyt bore it out.
NEW WEBSITE! www.mikebrooksflintlocks.com
Say, any of you boys smithies? Or, if not smithies per se, were you otherwise trained in the metallurgic arts before straitened circumstances forced you into a life of aimless wanderin'?

Online bob in the woods

  • Hero Member
  • *****
  • Posts: 4532
Re: rebarrelling a TVM
« Reply #2 on: April 21, 2013, 03:44:31 PM »
I would sell it, and have Mike Brooks build you a smoothbore.
Seriously..unless you are attached to the piece, investing more money to switch barrels, bore the barrel etc  may not be the best way to go.

Offline Dan'l 1946

  • Hero Member
  • *****
  • Posts: 628
Re: rebarrelling a TVM
« Reply #3 on: April 21, 2013, 04:12:58 PM »
  What Bob said.

Offline prairieofthedog

  • Jr. Member
  • **
  • Posts: 97
Re: rebarrelling a TVM
« Reply #4 on: April 21, 2013, 06:52:56 PM »
What Mike Brooks said.If you have a gun and will use it more in a different caliber by all means do it.Bob is good and fast,and that job should not cost over 100 bucks.

Offline pathfinder

  • Hero Member
  • *****
  • Posts: 731
Re: rebarrelling a TVM
« Reply #5 on: April 22, 2013, 12:32:02 AM »
Yup,yup,and yup. ;D
Not all baby turtles make to the sea!  Darwinism. It’s works!