« previous next »
Pages: [1]   Go Down

Author Topic: Looking for builder to shorten barrel and stock  (Read 1022 times)

Offline Rsl

  • Jr. Member
  • **
  • Posts: 86
Looking for builder to shorten barrel and stock
« on: April 12, 2018, 07:36:30 PM »
Hello.  Looking for a skilled builder to shorten barrel and stock on a Dixie Tennessee flinter.
Cut new crown , shorten stock. Basically make it look like it was made that way.
Thanks rick.
Rlopian@yahoo.com
Logged

Offline smokinbuck

  • Hero Member
  • *****
  • Posts: 2960
Re: Looking for builder to shorten barrel and stock
« Reply #1 on: April 12, 2018, 09:11:40 PM »
Rick,
Did exactly that. Took off 6", poured a nose cap, took off about half of the excess wood and refinished it. Looks good and handles great, total different balance.
Mark
Logged
Mark

Offline David Rase

  • Hero Member
  • *****
  • Posts: 4286
  • If we need it here, make it here. Charlie Daniels
Re: Looking for builder to shorten barrel and stock
« Reply #2 on: April 12, 2018, 09:53:07 PM »
A location of where you live might help to get a response.

We just did the same thing as Mark said on a .50 Dixie Tennessee rifle our BP club donated to the Washington State Muzzleloaders Association for their annual fundraising auction.  We also shortened the lower forestock to accommodate adding an entry pipe and added a grease hole.  It turned out great!
 
David
Logged
Pages: [1]   Go Up
« previous next »