Author Topic: Building a Tennessee Rifle  (Read 7246 times)

Offline Bill Raby

  • Sr. Member
  • ****
  • Posts: 424
Re: Building a Tennessee Rifle
« Reply #50 on: February 19, 2019, 08:33:10 PM »
I have not really had any trouble with that. Obviously stain will not penetrate the seam. If the wood that you glue is a tight fit you just get a thin line that is not likely to be ever noticed against the grain or the curl. Problem that i have is that the glue tends spread out a bit on the surface. That won't stain. But it does not penetrate very deep in the wood and can be sanded away fairly easily.

Offline Bill Raby

  • Sr. Member
  • ****
  • Posts: 424
Re: Building a Tennessee Rifle
« Reply #51 on: February 19, 2019, 09:49:14 PM »
Here is Part 29


Offline Bill Raby

  • Sr. Member
  • ****
  • Posts: 424
Re: Building a Tennessee Rifle
« Reply #52 on: February 24, 2019, 03:15:51 PM »
Here is Part 30


Offline Bill Raby

  • Sr. Member
  • ****
  • Posts: 424
Re: Building a Tennessee Rifle
« Reply #53 on: March 02, 2019, 07:19:26 AM »
Here is Part 31


Offline Mikecooper

  • Full Member
  • ***
  • Posts: 150
Re: Building a Tennessee Rifle
« Reply #54 on: March 02, 2019, 07:01:57 PM »
on curly maple like that you should try cutting cross grain with that gouge. 

Offline Bill Raby

  • Sr. Member
  • ****
  • Posts: 424
Re: Building a Tennessee Rifle
« Reply #55 on: March 07, 2019, 06:39:52 AM »
Here is Part 32


Offline Bill Raby

  • Sr. Member
  • ****
  • Posts: 424
Re: Building a Tennessee Rifle
« Reply #56 on: March 12, 2019, 04:48:13 AM »
Here is Part 33


Offline Bill Raby

  • Sr. Member
  • ****
  • Posts: 424
Re: Building a Tennessee Rifle
« Reply #57 on: March 15, 2019, 01:10:15 PM »
Here is Part 34


Offline Bill Raby

  • Sr. Member
  • ****
  • Posts: 424
Re: Building a Tennessee Rifle
« Reply #58 on: March 18, 2019, 06:20:18 PM »
Here is Part 35


Offline Bill Raby

  • Sr. Member
  • ****
  • Posts: 424
Re: Building a Tennessee Rifle
« Reply #59 on: March 21, 2019, 01:17:17 PM »
Here is Part 36