AmericanLongRifles Forums
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
News:
Home
Help
Login
Register
AmericanLongRifles Forums
»
General discussion
»
Gun Building
»
Did a little carving today...
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: Did a little carving today... (Read 1181 times)
looper
Full Member
Posts: 139
Did a little carving today...
«
on:
August 14, 2019, 06:01:12 AM »
I braved the 100 degree heat today to inlet a Colerain 42" A weight into a nice piece of hard maple today. A couple of hours and a gallon of water later...
Logged
BOB HILL
Hero Member
Posts: 2223
Re: Did a little carving today...
«
Reply #1 on:
August 14, 2019, 01:45:29 PM »
Looking good, Looper. You’re sure right about the heat. We’ve been working on kitchen cabinets this week. PM sent.
Bob
Logged
South Carolina Lowcountry
Dan Fruth
Hero Member
Posts: 552
Re: Did a little carving today...
«
Reply #2 on:
August 14, 2019, 03:10:09 PM »
Hey Looper, Is that a Don Allen machine, or one you built?
Logged
The old Quaker, "We are non-resistance friend, but ye are standing where I intend to shoot!"
looper
Full Member
Posts: 139
Re: Did a little carving today...
«
Reply #3 on:
August 14, 2019, 03:25:47 PM »
It’s a Don Allen.
Logged
hanshi
Hero Member
Posts: 5310
My passion is longrifles!
Re: Did a little carving today...
«
Reply #4 on:
August 14, 2019, 09:02:48 PM »
So far, very good work!
Logged
!Jozai Senjo! "always present on the battlefield"
Young guys should hang out with old guys; old guys know stuff.
Print
Pages: [
1
]
Go Up
« previous
next »
AmericanLongRifles Forums
»
General discussion
»
Gun Building
»
Did a little carving today...