AmericanLongRifles Forums

General discussion => Gun Building => Topic started by: PPatch on January 28, 2013, 08:56:50 PM

Title: Silver wire and inlay material
Post by: PPatch on January 28, 2013, 08:56:50 PM

Gentlemen;

Looking to purchase some silver inlay materials - I have settled on 10ga (1mm or .3937in.) .999 pure silver for fabracating the inlays and am thinking .925 sterling for making the tiny brads.

What diameter for the brad making wire? I am thinking 1.6mm/.06299 dia.

Your suggestions?

Thank you in advance.

dave

Title: Re: Silver wire and inlay material
Post by: SuperCracker on January 28, 2013, 09:23:04 PM

I think that Stonewall has sterling brads ready made.  I know I picked up a couple of bags at Dixons and I'm pretty sure it was from them.

Title: Re: Silver wire and inlay material
Post by: keweenaw on January 29, 2013, 12:10:34 AM

I would use sterling rather than fine silver for the inlays, I use 0.040".  I think 1/16" is too big for brads. 

Tom

Title: Re: Silver wire and inlay material
Post by: Mark Elliott on January 29, 2013, 12:49:12 AM

You can try Hoover & Strong for mill goods but they can be kinda funny about who they will sell to.   You have to call them to find out if they will sell to you.   They don't want to sell to anyone who will compete with their primary customers, jewelers.    Rio Grande is another option.   They apparently sell to any one.   Generally,  sterling is all that is available in silver and I would think that would be good enough.    If anybody could provide you with fine silver, that would be Hoover & Strong as they are refiners.

Title: Re: Silver wire and inlay material
Post by: louieparker on January 29, 2013, 03:08:52 AM

Hauser & Miller Co. in St Louis  carries coin silver, sterling and fine silver
..Their phome # 314 487 1311...............Louie

Title: Re: Silver wire and inlay material
Post by: louieparker on January 29, 2013, 03:23:23 AM

You can buy sterling silver wire from Hauser & miller co...Not sure what sizes are available..I get about .040......LP

Title: Re: Silver wire and inlay material
Post by: PPatch on January 29, 2013, 06:00:42 AM

Thanks for the tip Louie - I will check that St Lo company out. Yes .040 wire, sounds better than .062... getting into NAILS with that.  :)

Thanks everyone - I believe I'm squared away now.

Title: Re: Silver wire and inlay material
Post by: PPatch on January 29, 2013, 06:02:27 AM

Quote from: SuperCracker on January 28, 2013, 09:23:04 PM

I think that Stonewall has sterling brads ready made.  I know I picked up a couple of bags at Dixons and I'm pretty sure it was from them.

I will phone them and see if they have it - thank you.