AmericanLongRifles Forums
General discussion => Gun Building => Topic started by: dannylj on April 04, 2013, 11:24:32 PM
-
I am refinishing an iron mounted mountain rifle. Having had good luck with Laurel Mountain Barrel Brown and Degreaser and running a little low is there anything I can add to what I have left that will not significally slow the rusting process to keep from having to order anther bottle? I'd like to add about 25% of something to what I have. Danny
-
Danny; L M F browning is quite agressive and I like it diluted about half with water.
A bit slower but it reduses the risk of pitting.
Just my personal thoughts. No guarentees. Bob
-
Thanks Bob. That is just what I wanted to hear.
-
I don't know about Laurel Mt. products, but have had experience with True Brown, and Ol' Thunder in the past. An old gunsmith told me that to get a lighter brown, with really fine grain, reduce the solution, with denatured alcohol, of better Shellac reducer ( A more concentrated form).
Hungry Horse
-
Danny; L M F browning is quite agressive and I like it diluted about half with water.
A bit slower but it reduses the risk of pitting.
Just my personal thoughts. No guarentees. Bob
You are so correct, Bob. I dilute to 50/50 with distilled water. Great solution for bringing out Damascus, also
-
Just finished browning a LR w/ LMF and for unknown reasons {anyways to me}, a shiny "crust" formed on some lock parts and areas of the bbl after the third coat. Carding w/ denim couldn't break through the crust, so used green Scotchbrite and that did. After removing the crust, I lightly went over all surfaces of all the parts and after 2 more coats, achieved a nicely colored, lightly etched matte finish. The browning was done in a makeshift "sweatbox" which previously worked fine. Seeing I've had after rust problems using baking soda, I've been using household ammonia and it really "kills" the rusting process. Diluting the LMF sounds like good advice and will do on the next LR. Thanks for the info......Fred