AmericanLongRifles Forums
General discussion => Black Powder Shooting => Topic started by: Nessmuck on April 13, 2019, 09:26:45 PM
-
Iam also a fur trapper ...and that right there is one of my brass Trap Tags ! It’s on my .62 Foozee De Chasse ....which has a front sight only. I drilled an 1/8 and 1/16 inch peep hole. It’s easliy adjustable...just bend up or down..left and right. Should be good enough to work up consistent loads from the bench position. Then maybe take some sight measurements and get creative and make a solid rear peep sight..that’s also removable.
(https://i.ibb.co/j6yrWkh/2-E418012-2-ECF-4-E55-A0-B0-5-EA51-E7-EF845.jpg) (https://ibb.co/gjSRPZy)
-
I understand it's just temporary but that's really ugly.
-
^^^^^^^^ was going to call it my Ghetto Sight....
-
It seems pretty high. Does it work there?
-
I think it's just another case off American ingenuity. Good job.
Mark
-
It seems pretty high. Does it work there?
I just installed it...now to get to the range.
-
I think it's just another case off American ingenuity. Good job.
Mark
Yankee ingenuity.....I will just bend it ...till it works
-
That looks like an extremely smart idea to me. You have short circuited a lot of misery by making that prototype. Good move. God Bless, Marc
-
Use my tags for shims ,no end of uses for trap tags/Ed
-
This will probably turn into one of those Murphy's Law situations... It's dirt cheap, stupid simple, and uglier than homemade soap... So it will probably work amazingly well.
And based on my experience, dead animals are usually mum on the aesthetics of the items that killed them. Lol
Mike
-
This could be/would be a great idea for testing load combos for accuracy potential. For us senior shooters any way. Once you find your best shooting load you could sight your gun in to the regular sights with the most accurate load combo.