AmericanLongRifles Forums
General discussion => Black Powder Shooting => Topic started by: 1911tex on June 27, 2013, 04:40:57 PM
-
New poster, but loooooooooong time B/P flinter. What do you fellas use to waterproof/seal the mortise and bbl channels?
-
A true boiled inseed oil soft varnish cut with some aged Turpentine just like the rest of the stock. But not enough to cause any significant buildup.
Dan
-
Generally speaking use the same sealer you used on the rest of the gun.
dp
-
I concur with whatever u use for stock sealer/finish.
-
I also like a linseed oil finish, but before final assembly I liberally coat the barrel channel/ tang inlet with Johnson's Paste Wax and then press the barrel down into it, replace the barrel pins/keys and then wipe the excess off.
I do this in the furniture piece inlets also.
Seems to do a good job keeping moisture out from under things.
Mark
-
Thanks fellas, now I will reconsider my original thought of using Tung Oil which is what I had originally finished the outside of the gun; (it soaks into the wood). I have experienced a small amount of wood rot about the size of dimes (rain, barrel cleaning, oil, etc) over many years of not removing the barrel periodically for inspection and apparently water pooled up in couple of low spots...which I am going to fill with epoxy after scraping out the small amount of rot. This flinter has survived 45 years of use all over south Texas. The bbl. underside also had a very small amount of rust is a couple of spots. I am not about to give it up...it is still a beautiful gun...kinda like old Willies guitar.
Modified: Just thinking of my above comment about the age of my .50 flinter...please don't misunderstand, I can afford a newer rifle many times over, but this gun is like an old pair of boots.......it just fits!