AmericanLongRifles Forums

General discussion => Shop Made Tools => Topic started by: Tenn Hills Guy on November 23, 2015, 09:14:04 PM

Title: Making spoon bits?
Post by: Tenn Hills Guy on November 23, 2015, 09:14:04 PM

Do any of you make your own spoon bits? I attempted to make one from some 3/16's music wire and it actually worked pretty well to make a ramrod channel into a wheellock pistol stock.  I'd like to see a 'properly made' bit, if possible.  Bill

Title: Re: Making spoon bits?
Post by: dogcatcher on November 23, 2015, 09:53:01 PM

I have never made one that small, and I cheated when I made mine.  I use spade bits and grind the end off round. 

(https://pipesmagazine.com/wp-content/blogs.dir/1/files/album/963/bits-436x600.jpg)

Title: Re: Making spoon bits?
Post by: dogcatcher on November 30, 2015, 08:15:31 AM

I was off on another tangent and ran in to another type of drill bit.  Research D-bit, It might be what you are looking for, but I can't figure out how to make it that small. 

Title: Re: Making spoon bits?
Post by: James Wilson Everett on November 30, 2015, 03:26:03 PM

Guys,

There is a small bit of historical evidence that nose bits were used, not spoon bits, for the ramrod hole drill bit.  Certainly this is not a definitively true statement as I feel certain that a wide variety of drill bits were actually used in the period, including spoon bits.  However, the nose bit is specifically designed to drill long straight holes in endgrain wood whereas the spoon bit is specifically designed to drill holes that are at a definite angle to the endgrain.  Here is a discussion about a single ramrod hole drill original tool.

Jim

http://americanlongrifles.org/forum/index.php?topic=27973.msg266805#msg266805