AmericanLongRifles Forums

General discussion => Gun Building => Topic started by: Brian Jordan on April 13, 2018, 09:20:25 PM

Title: Clay used for engraving
Post by: Brian Jordan on April 13, 2018, 09:20:25 PM

I am looking for a source for this clay. I believe it hardens once formed and is made malleable again once heated.

Thanks

Title: Re: Clay used for engraving
Post by: bama on April 13, 2018, 09:26:34 PM

GRS  makes I think what you are looking for. It is a plastic type of material not a clay. It works great just heat it with a heat gun, set your part, let it cool to harden and engrave away. Thermoloc I think is what it is called. I am using some at this very moment.

Title: Re: Clay used for engraving
Post by: tallbear on April 13, 2018, 09:52:38 PM

Melsdad

It can be found here...https://www.grs.com/browse/workholding/thermo-loc/ (https://www.grs.com/browse/workholding/thermo-loc/)

Mitch

Title: Re: Clay used for engraving
Post by: Brian Jordan on April 13, 2018, 10:00:44 PM

Thanks Guys found it!