AmericanLongRifles Forums

General discussion => Gun Building => Topic started by: looper on August 14, 2019, 06:01:12 AM

Title: Did a little carving today...
Post by: looper on August 14, 2019, 06:01:12 AM

I braved the 100 degree heat today to inlet a Colerain 42" A weight into a nice piece of hard maple today. A couple of hours and a gallon of water later...
(https://i.imgur.com/QPLex8V.jpg)
(https://i.imgur.com/J7bTJhs.jpg)
(https://i.imgur.com/sKCgegF.jpg)
(https://i.imgur.com/fW5Ikj2.jpg)

Title: Re: Did a little carving today...
Post by: BOB HILL on August 14, 2019, 01:45:29 PM

Looking good, Looper. You’re sure right about the heat. We’ve been working on kitchen cabinets this week. PM sent.
Bob

Title: Re: Did a little carving today...
Post by: Dan Fruth on August 14, 2019, 03:10:09 PM

Hey Looper, Is that a Don Allen machine, or one you built?

Title: Re: Did a little carving today...
Post by: looper on August 14, 2019, 03:25:47 PM

It’s a Don Allen.

Title: Re: Did a little carving today...
Post by: hanshi on August 14, 2019, 09:02:48 PM

So far, very good work!