AmericanLongRifles Forums
General discussion => Antique Accoutrements => Topic started by: Dennis Daigger on October 26, 2020, 08:23:54 PM
-
I have a Continental cape gun (.54 caliber and rifled 28 gauge) and I've dedicated these accessories to it. The shot pouch measure drops a 1 1/8 oz of #6 shot. For use with the cape gun I modified it by inserting two 28 gauge over powder wads in the base and it now gives me an appropriate 3/4 oz charge of #6. I was initially using this pouch for my 16 gauge double before I found other shot flasks for it. The second measure was made for use with the 16 gauge and it drops 1 1/4 oz of #6 shot. The chamois pouch is now dedicated to the cape gun using the modified original measure.
(https://i.ibb.co/WzFfrZH/Chamois1.jpg) (https://ibb.co/ZgKxQ5f)
(https://i.ibb.co/7bZnBmj/Chamois3.jpg) (https://ibb.co/Tr74J3Y)
(https://i.ibb.co/NTfN5L4/Chamois4.jpg) (https://ibb.co/g4QWNDn)
This flat horn flask came to me as a very rusted, corroded and unusable flask. I normally don't buy flasks that aren't right to begin with. The only cleaning I do to any of them is what is necessary to make them useable. I got this one cheaply so its condition was not so much an issue and it did take a lot of work to make it useable. It drops charges between 45 at the bottom end to 52 grains of FFFg at the top end which is lighter than I was looking for. The cape gun had been giving me very good accuracy with 50 grains of powder but I had hoped I could shoot fairly heavy charges in it. At 60 grains the groups began enlarging and continued to do so as the charge increased. An astute member of this forum suggested I check the twist rate and it was 1:35 so as it turns out this flask drops charges that are ideal for the cape gun. Turns out I have a close range Black Forest boar rifle. Or a Sitka blacktail deer rifle after the bears are tucked in.
(https://i.ibb.co/mX1TsqD/NoName2.jpg) (https://ibb.co/KLRhZq0)
(https://i.ibb.co/SNKmqKS/NoName4.jpg) (https://ibb.co/LSCg4CK)
(https://i.ibb.co/rZkv4dv/NoName3.jpg) (https://ibb.co/gDy6z46)
-
Hi Dennis
That' s a wonderful restauration restauration of a flat horn.
I own a similar Horn, but mine has a different type of charger, that does not work.
Somebody told me, that this type of horns was industrially made. Is this true?
(https://i.ibb.co/8cxxbZs/20201113-153351.jpg) (https://ibb.co/tX22zrK)