AmericanLongRifles Forums
General discussion => Shop Made Tools => Topic started by: 577SXS on April 02, 2021, 04:37:26 PM
-
I was trying to come up with a way to hold a rasp for shaping the sides of a butt stock and had an idea. I copied a handle from one of my old planes that I really liked. I shaped the handle and fitted it to a Iwasaki half round rasp. I them used JB Kwik to attach it. I really like the way it works for those curved sides along the comb and below the cheek.
(https://i.ibb.co/XX5TBBs/IMG951700.jpg) (https://ibb.co/CB9Fdd7)
-
Now that’s a good idea! You could glue a ball knob on the front for two hand control, just like a plane.
Greg
-
Greg, Now I should have done that and made it all in one piece. Why didn't I think of that!
-
I had a buddy who drilled his and put a wooden handle on the end. I can pretty much guarantee you that JB Weld won't hold up to the pressures that I put on a rasp when I'm getting serious with it. Of course I'm a heavy handed oaf too.
-
I was going to solder a block to file to mount handle to then decided to JB it first. I glued a bunch of stuff with JB Kwik and love the stuff. If it falls off I'll go the other route.
-
Golf balls
-
Golf balls don't allow the file to lay flat on a long surface. They do make a good handle though.
-
I picked up a Globemaster Power File Handle many years ago for just such use
(https://i.ibb.co/Fmj2TGg/File-Holder-1.jpg) (https://ibb.co/34L2ZtB)
(https://i.ibb.co/pf0zNDH/File-Holder-2.jpg) (https://ibb.co/6HnPGhK)