AmericanLongRifles Forums
General discussion => Gun Building => Topic started by: Ron Scott on July 26, 2021, 05:37:19 PM
-
I am preparing molds for the Pistol mounts intended for my NMLRA seminar. I am curious if there is enough interest in a nice pistol lock to justify the construction of molds. I might just do the external parts and plan for folks to use small Siler internals.
(https://i.ibb.co/r4Nwbyr/DSC01376.jpg) (https://ibb.co/FgCDs7T)
-
I'd be interested in one or two sets depending on price. I'm also interested in the brass castings depending on price.
Best regards
Rolf
-
Hi Ron,
What is the length of the plate? I assume you are casting in the chiseled decoration or could some waxes be done with the externals smooth?
dave
-
Sounds interesting to me.
-
Ron, I'd be interested in the chiseled pistol lock AND the brass furniture as well.
-
I'm in for two pistol locks. If they look like the pics you are showing I can't say no.
-
Ron, you know I'll be in for the pistol molds. At least two.
-
I am away from home until later today. I will measure the lock and post the dimensions. Yes, these would be cast with the decorative details.
-
Ron I'd be interested in 1 or 2 also.
-
Dave,
The lock plate is 4 5/8 inches long. The lock would have the decoration cast into it. If you were interested, I could send you waxes that you could carve smooth and have cast smooth.
-
I would be glad to get two of these. I would also love to get the brass fittings as well.