AmericanLongRifles Forums
General discussion => Shop Made Tools => Topic started by: Kevin on August 18, 2021, 08:34:43 PM
-
I had a raw horn that had the outer layer of the core adhered over much of the inside, especially in the small end.
A couple minutes bending the barbs on a metal "spine" from a worn out windshield wiper blade and I had a very flexible scraper to get into any tight spot. It made short work of the unwanted layer after a soak in some hot water.
Enjoy,
Kevin
(https://i.ibb.co/XkN2XQq/SONY-DSC.jpg) (https://ibb.co/CsN1Bcf)
(https://i.ibb.co/0nxdQCk/SONY-DSC.jpg) (https://ibb.co/kGtWM4p)
(https://i.ibb.co/RHRkN0q/SONY-DSC.jpg) (https://ibb.co/Hg5fCzj)