« previous next »
Pages: [1]   Go Down

Author Topic: Banded Horn W/Pewter/Antler Tip  (Read 2719 times)

Offline Tim Crosby

  • Administrator
  • Hero Member
  • *
  • Posts: 18392
  • AKA TimBuckII
Banded Horn W/Pewter/Antler Tip
« on: March 02, 2011, 09:36:52 PM »
 
  This one is about 13 1/4” around the outside curve. The Walnut base is hollowed out and held in buy the same four pins that hold the base band on, The other two bands are held with three steel pin each. The antler tip is pinned to the pewter collar with three steel pins and then the collar is pinned to the horn with three more.

 Tim C.





Logged

JohnnyM

  • Guest
Re: Banded Horn W/Pewter/Antler Tip
« Reply #1 on: March 02, 2011, 11:18:33 PM »
Shazam!  That's a nice lookin' horn!

Regards,
Johnny
Logged

Offline Ken G

  • Hero Member
  • *****
  • Posts: 5526
  • F & AM #758
Re: Banded Horn W/Pewter/Antler Tip
« Reply #2 on: March 03, 2011, 05:42:11 AM »
Tim,
Looks great.  I love your banded horns. 
Ken
Logged
Failure only comes when you stop trying.

smorrison

  • Guest
Re: Banded Horn W/Pewter/Antler Tip
« Reply #3 on: March 03, 2011, 08:05:43 AM »
Yep, very nice one Tim.  I like the antler/pewter applied tip; very attractive over all.

Scott
Logged

Offline skillman

  • Hero Member
  • *****
  • Posts: 996
  • The Usual Suspect
Re: Banded Horn W/Pewter/Antler Tip
« Reply #4 on: March 03, 2011, 07:13:12 PM »
Nice horn Tim. I tried your method of turning the pewter band and used it to repair a cracked tip. It worked well. Good "tip". :D :D

Steve
Logged
Steve Skillman
Pages: [1]   Go Up
« previous next »