« previous next »
Pages: [1]   Go Down

Author Topic: entry ramrod pipe  (Read 3086 times)

Offline yip

  • Hero Member
  • *****
  • Posts: 1050
entry ramrod pipe
« on: May 03, 2013, 10:33:32 PM »
  i'm looking for a entry pipe with a high step,from thimble too flare. any thoughts?
Logged

Offline Acer Saccharum

  • Hero Member
  • *****
  • Posts: 19311
    • Thomas A Curran
Re: entry ramrod pipe
« Reply #1 on: May 03, 2013, 10:45:19 PM »
Make or modify might be your two choices.
Logged
Tom Curran's web site : http://monstermachineshop.net
Ramrod scrapers are all sold out.

Offline J. Talbert

  • Hero Member
  • *****
  • Posts: 2309
Re: entry ramrod pipe
« Reply #2 on: May 04, 2013, 01:58:43 AM »
Why?

Generally looks will suffer.  ???

Just wondering,
Jeff
Logged
There are no solutions.  There are only trade-offs.”
Thomas Sowell

Offline yip

  • Hero Member
  • *****
  • Posts: 1050
Re: entry ramrod pipe
« Reply #3 on: May 04, 2013, 04:10:05 AM »
 while drilling ramrod hole, the drill wondered a little low,so i can't take off the wood on the bottom the amount i wanted to. i got 3/16 at the entry thimble, and around 1/8 at the trigger guard, if that makes sense. any suggestions?
Logged

Offline Pete G.

  • Hero Member
  • *****
  • Posts: 2013
Re: entry ramrod pipe
« Reply #4 on: May 04, 2013, 05:04:49 PM »
Taper the lower fore end to match. Cut another 1/16"  at the pipe.
Logged

mjm46@bellsouth.net

  • Guest
Re: entry ramrod pipe
« Reply #5 on: May 04, 2013, 06:05:29 PM »
Just taper the bottom of the forearm. 1/8" below the RR entry is perfect, then just taper to the trigger guard from there.
Logged
Pages: [1]   Go Up
« previous next »