« previous next »
Pages: [1]   Go Down

Author Topic: Sheet brass thickness  (Read 3229 times)

Offline FALout

  • Hero Member
  • *****
  • Posts: 875
Sheet brass thickness
« on: March 10, 2015, 01:07:11 PM »
I'm getting some materials together for a northwest trade gun build.  I was wondering how thick sheet brass would be best for making a butt plate and trigger guard?    Is there any good source for pictures of trade guns?  I've seen nice reproductions here, but not a lot of originals.
Logged
Bob

Offline Keb

  • Hero Member
  • *****
  • Posts: 1193
  • south Ohio
Re: Sheet brass thickness
« Reply #1 on: March 10, 2015, 01:44:28 PM »
I make mine from .062" brass.
Logged

Offline Mike Brooks

  • Hero Member
  • *****
  • Posts: 13415
    • Mike Brooks Gunmaker
Re: Sheet brass thickness
« Reply #2 on: March 10, 2015, 02:46:35 PM »
Quote from: FALout on March 10, 2015, 01:07:11 PM
I'm getting some materials together for a northwest trade gun build.  I was wondering how thick sheet brass would be best for making a butt plate and trigger guard?    Is there any good source for pictures of trade guns?  I've seen nice reproductions here, but not a lot of originals.
They got books all about NW guns with lots of pictures. They even sell them.
Logged
NEW WEBSITE! www.mikebrooksflintlocks.com
Say, any of you boys smithies? Or, if not smithies per se, were you otherwise trained in the metallurgic arts before straitened circumstances forced you into a life of aimless wanderin'?

Offline RAT

  • Hero Member
  • *****
  • Posts: 699
Re: Sheet brass thickness
« Reply #3 on: March 10, 2015, 04:53:48 PM »
Get Gooding's book on Hudson's Bay Co. guns...

http://www.trackofthewolf.com/Categories/PartDetail.aspx/278/1/BOOK-TGHBC

It's the best I've seen.

FYI... the trigger guards were iron.
Logged
Bob

Offline okieboy

  • Hero Member
  • *****
  • Posts: 822
Re: Sheet brass thickness
« Reply #4 on: March 10, 2015, 05:31:50 PM »
 I highly recommend Ryan R. Gale's "For Trade and Treaty". It provides high end photography with extensive dimensions, right down to the thickness of sheet metal used in ramrod pipes. I have never had a gun book that delivered as much of what I wanted as this one.
Logged
Okieboy

Offline FALout

  • Hero Member
  • *****
  • Posts: 875
Re: Sheet brass thickness
« Reply #5 on: March 11, 2015, 02:45:54 AM »
Thanks RAT and okieboy, those suggested books are just what I'm looking for.
Ken, I figured the but plate would be thicker, might even have some that thickness.
Logged
Bob
Pages: [1]   Go Up
« previous next »