« previous next »
Pages: [1]   Go Down

Author Topic: Engraving Question  (Read 1769 times)

Offline Mike Lyons

  • Hero Member
  • *****
  • Posts: 1242
  • Afghanvet
Engraving Question
« on: August 30, 2018, 09:17:24 PM »
How are these little scoops made? Is there a specific graver to do these? I’ve been practicing engraving and these things are driving me more crazy. This picture isn't the best but it is the best I can find online.  They are a lot more refined and well defined on some rifles.  They are basically egg shaped on top and flat on the bottom. 

« Last Edit: August 30, 2018, 09:19:30 PM by Afghanvet »
Logged

Offline rich pierce

  • Administrator
  • Hero Member
  • *
  • Posts: 19409
Re: Engraving Question
« Reply #1 on: August 30, 2018, 09:54:25 PM »
I made a graver of round drill rod about 5/32” diameter and put a small belly on it. Works great for those. But it’s unsteady for a long deep round line. Who cares? It’s my scooper.

I used it for the deeper lines near the lock nails on my Fainot sideplate. I just kept narrowing the graver till it was right.


poems by Bertolt Brecht
« Last Edit: August 30, 2018, 09:59:25 PM by rich pierce »
Logged
Andover, Vermont

Offline Chowmi

  • Hero Member
  • *****
  • Posts: 843
Re: Engraving Question
« Reply #2 on: August 30, 2018, 11:22:33 PM »
It’s a round bottomed graver, rather than a square 90 degree graver.
You can make one on your own, or Steve Lindsay has a template to create and sharpen one.
Logged
Cheers,
Chowmi

NMLRA
CLA
Pages: [1]   Go Up
« previous next »