« previous next »
Pages: [1]   Go Down

Author Topic: Questions about early forging techniques  (Read 2918 times)

Offline 44-henry

  • Hero Member
  • *****
  • Posts: 1126
Questions about early forging techniques
« on: June 22, 2009, 12:34:05 AM »
What forging techniques would have been employed in the mass production of gun locks in the mid 1800's I would assume that dies were used, but would some form of drop hammer been employed?
Logged

Offline Steve Bookout

  • Sr. Member
  • ****
  • Posts: 333
  • AF & AM, #59
    • Toad Hall Rifleshop
Re: Questions about early forging techniques
« Reply #1 on: June 22, 2009, 05:05:23 AM »
I have seen an old photo (of the Henry shop, I believe) that showed a trip hammer in use.  Cheers, Bookie
Logged
Steve Bookout, PhD, CM, BSM
University of South Viet Nam
Class of 1969
Class of 1970
Class of 1971

Offline jerrywh

  • Hero Member
  • *****
  • Posts: 8885
    • Jerrywh-gunmaker- Master Engraver FEGA.
Re: Questions about early forging techniques
« Reply #2 on: June 22, 2009, 06:15:25 AM »
SEE BOOK-----Harpers Ferry Armory and the New Technology By Merritt Roe Smith
Logged
Nobody is always correct, Not even me.

northmn

  • Guest
Re: Questions about early forging techniques
« Reply #3 on: June 23, 2009, 04:43:42 PM »
I got a little curious about the start of mass production in the early 1800's.  Eli Whitney was also credited with helping to develop the milling machine.  Not all parts were forged, some machined by this time. 

DP
Logged
Pages: [1]   Go Up
« previous next »