« previous next »
Pages: [1]   Go Down

Author Topic: Drill Rod for Burnisher  (Read 1197 times)

Offline Nhgrants

  • Sr. Member
  • ****
  • Posts: 255
Drill Rod for Burnisher
« on: April 09, 2019, 12:06:05 AM »
I have a piece of 3/8 Drill Rod.  Would this make an acceptable
Scraper burnisher?
Logged

Offline Dphariss

  • Hero Member
  • *****
  • Posts: 9920
  • Kill a Commie for your Mommy
Re: Drill Rod for Burnisher
« Reply #1 on: April 09, 2019, 12:44:07 AM »
Quote from: Nhgrants on April 09, 2019, 12:06:05 AM
I have a piece of 3/8 Drill Rod.  Would this make an acceptable
Scraper burnisher?
Should be OK. However, if the scraper is pretty hard, like some store bought types, I use the shank of a 3/8-1/2" drill bit.  These are too thin to keep sharpening on the sides and work better with a rolled edge.

Dan
Logged
He who dares not offend cannot be honest. Thomas Paine

Offline D. Taylor Sapergia

  • Member 3
  • Hero Member
  • *
  • Posts: 12671
Re: Drill Rod for Burnisher
« Reply #2 on: April 09, 2019, 02:23:27 AM »
Lee Valley tools sells a burnisher purpose made by Veritas...not expensive and a great tool.
Logged
D. Taylor Sapergia
www.sapergia.blogspot.com

Art is not an object.  It is the excitement inspired by the object.

Offline crankshaft

  • Full Member
  • ***
  • Posts: 124
Re: Drill Rod for Burnisher
« Reply #3 on: April 09, 2019, 04:19:45 AM »

 Chevy pushrod?
Logged

Offline EC121

  • Hero Member
  • *****
  • Posts: 1611
Re: Drill Rod for Burnisher
« Reply #4 on: April 09, 2019, 05:06:53 AM »
I use an old knife sharpening steel I got somewhere.  Even has a handle on it.
Logged
Brice Stultz

Lzymtlsmth

  • Guest
Re: Drill Rod for Burnisher
« Reply #5 on: April 09, 2019, 03:28:39 PM »
Anything that is hardened steel. USA made Allen wrench.
Logged
Pages: [1]   Go Up
« previous next »