« previous next »
Pages: [1]   Go Down

Author Topic: Question for Engravers going to Dixons.  (Read 2400 times)

J Shingler

  • Guest
Question for Engravers going to Dixons.
« on: July 22, 2009, 05:27:45 AM »
Hey guys. I have a request. I am looking for advise or tips on how to refresh or recut cast in engraving. If I would bring this wall gun I built up to Dixons would someone throw a few ideas my way? How about it Rich or Acer? Anyone interested in seeing this Brown Bess on steroids? There are just a few areas that need cleaned up after I cleaned up the castings. Side plate and top of the tang on the butplate.
Can not wait! Leaving Thurs after work and will be in about noon Fri! 
See you there!!
Jeff
Logged

Offline E.vonAschwege

  • Global Moderator
  • Hero Member
  • *
  • Posts: 3118
    • von Aschwege Flintlocks
Re: Question for Engravers going to Dixons.
« Reply #1 on: July 22, 2009, 06:06:19 AM »
Jeff,
   I'd love to see a bess on steroids!  I'm sure others will be able to help you on the engraving, but I just want to see the wall gun.  Looking forward to seeing you there!
-Eric
Logged
Former Gunsmith, Colonial Williamsburg www.vonaschwegeflintlocks.com

J Shingler

  • Guest
Re: Question for Engravers going to Dixons.
« Reply #2 on: July 22, 2009, 11:10:32 PM »
Ok I will tote it along. I will be happy to show It to you. That and I am sure I can find someone with an opinion. Good bad or evil!
Jeff
Logged
Pages: [1]   Go Up
« previous next »