« previous next »
Pages: [1]   Go Down

Author Topic: Lock plate maker  (Read 1617 times)

Offline eggwelder

  • Jr. Member
  • **
  • Posts: 68
Lock plate maker
« on: May 28, 2020, 05:07:43 PM »
Looking to see if anyone recognizes this lock plate from any of the suppliers. Need a screw and a possible guide from the manufacturer for building it-
Logged

Offline Hungry Horse

  • Hero Member
  • *****
  • Posts: 5565
Re: Lock plate maker
« Reply #1 on: May 28, 2020, 05:20:09 PM »
 It’s a Northstar, or Northstar West plate. Both companies are out of business I believe.

  Hungry Horse
Logged

Offline redheart

  • Hero Member
  • *****
  • Posts: 599
Re: Lock plate maker
« Reply #2 on: May 28, 2020, 07:02:10 PM »
Quote from: Hungry Horse on May 28, 2020, 05:20:09 PM
It’s a Northstar, or Northstar West plate. Both companies are out of business I believe.

  Hungry Horse


HH,
I'm not certain , The sitting fox on my Northstar looks stamped in and this one looks cast into the plate, the fox on this one is also less detailed. I've never known HH to be wrong about anything and am hoping that this is a first. ;)
« Last Edit: May 28, 2020, 07:09:52 PM by redheart »
Logged

Offline Bob Roller

  • Hero Member
  • *****
  • Posts: 9687
Re: Lock plate maker
« Reply #3 on: May 29, 2020, 12:21:29 AM »
It may be able to incorporate a complete set of Siler parts both internally
and externally.Worth a look.
Bob Roller
Logged

Offline eggwelder

  • Jr. Member
  • **
  • Posts: 68
Re: Lock plate maker
« Reply #4 on: May 29, 2020, 02:05:53 AM »
 The circle fox is cast in, and i have all the parts in rough castings. Have built a small Siler from the same state before, but it came with Jim Chambers instructions, including drill bit sizes and tap sizes.
Logged

Offline Clint

  • Sr. Member
  • ****
  • Posts: 330
Re: Lock plate maker
« Reply #5 on: May 31, 2020, 04:57:08 AM »
Use number 8 screws to put the lock together. Start by fitting the tumbler to the plate. You can locate the tumbler hole by measuring the distance from the center of the flintcock to the lower jaw and transfering the length to the plate. (from the top edge of the fence to the center of the plate). After that it will go together like a tough puzzle. If you get stuck, sing out.
Clint
Logged

Offline little joe

  • Hero Member
  • *****
  • Posts: 685
Re: Lock plate maker
« Reply #6 on: May 31, 2020, 05:50:00 PM »
I think the plate is from Upper Missouri Trading Post in Nebraska Doc. Carlson and wife ran it. 1970 and 1980 and later.
Logged

Offline Hudnut

  • Full Member
  • ***
  • Posts: 231
Re: Lock plate maker
« Reply #7 on: June 03, 2020, 03:02:32 AM »

The bottom lock has a lockplate from the Upper Missouri Trading Company.  Only the lockplate, not the other parts.


Logged
Pages: [1]   Go Up
« previous next »