« previous next »
Pages: 1 [2]   Go Down

Author Topic: just a few little gaps  (Read 2879 times)

Offline Mike Brooks

  • Hero Member
  • *****
  • Posts: 13415
    • Mike Brooks Gunmaker
Re: just a few little gaps
« Reply #25 on: January 04, 2022, 01:38:06 AM »
It's a whole lot easier to file draft on the inlay and inlet it properly. The OP isn't going to have any gaps when he gets it all the way down.
Logged
NEW WEBSITE! www.mikebrooksflintlocks.com
Say, any of you boys smithies? Or, if not smithies per se, were you otherwise trained in the metallurgic arts before straitened circumstances forced you into a life of aimless wanderin'?

Offline yip

  • Hero Member
  • *****
  • Posts: 1050
Re: just a few little gaps
« Reply #26 on: January 04, 2022, 01:46:49 AM »
 Mike i did file a draft, i think i was trying to get it to tight of fit.
Logged

Offline Mike Brooks

  • Hero Member
  • *****
  • Posts: 13415
    • Mike Brooks Gunmaker
Re: just a few little gaps
« Reply #27 on: January 04, 2022, 03:00:36 AM »
You'll  be fine once you have it down where it needs to be. I've  done some big starslike that and  they are a pia.
Logged
NEW WEBSITE! www.mikebrooksflintlocks.com
Say, any of you boys smithies? Or, if not smithies per se, were you otherwise trained in the metallurgic arts before straitened circumstances forced you into a life of aimless wanderin'?
Pages: 1 [2]   Go Up
« previous next »