« previous next »
Pages: [1]   Go Down

Author Topic: Alamance Co. N.C. Horn  (Read 3251 times)

Offline Tim Crosby

  • Administrator
  • Hero Member
  • *
  • Posts: 18391
  • AKA TimBuckII
Alamance Co. N.C. Horn
« on: February 16, 2010, 11:20:50 PM »
 This is my interpretation of fig. 35 in Michael Briggs' Piedmont North Carolina Banded Powder Horns Hunting Bags & Bullet Molds It is listed as being form Alamance Co N.C. which is just east of Winston Salem, if I am not mistaken.
  This horn is about 12 1/2" around the outside curve, the Cherry base is about 2 1/2". The The screw tip is horn and about 2 1/4", threaded 1/2-13. The very tip of the original was missing so I guessed at it's design.
 Any comments, pro or con are welcome.

Tim C.   





« Last Edit: May 12, 2020, 09:53:41 PM by rich pierce »
Logged

george kevil

  • Guest
Re: Alamance Co. N.C. Horn
« Reply #1 on: February 17, 2010, 02:46:40 AM »
Tim,
Another great horn.I don't know how to give it a con just pros.
As always great clean lines. I really like the way the tip screws into the horn instead of the otherway around. A friend of mine just got a horn in a trade with a big enough end tap  so I think I'm going to do that after seeing yours.
Keep up the good work.
George
Logged

seesbirds

  • Guest
Re: Alamance Co. N.C. Horn
« Reply #2 on: February 17, 2010, 04:49:33 AM »
Tim,

Another beautiful job.  Nice going!

Mark
Logged

Offline G. Elsenbeck

  • Hero Member
  • *****
  • Posts: 1234
Re: Alamance Co. N.C. Horn
« Reply #3 on: February 17, 2010, 05:52:13 AM »
Way to go Tim.  Great looking horn with very pleasing lines.  I haven't got that book yet (it's on order though) so can't make any comparisons, but I'm sure you did a fine job on that.  Did you lightly stain this one? 
Gary
Logged
Journeyman in the Honourable Company of Horners (HCH) and a member in the Contemporary Longrifle Association (CLA)

There is a very fine line between "hobby" and "mental illness."

Offline Tim Crosby

  • Administrator
  • Hero Member
  • *
  • Posts: 18391
  • AKA TimBuckII
Re: Alamance Co. N.C. Horn
« Reply #4 on: February 17, 2010, 08:37:09 PM »
Quote from: G. Elsenbeck on February 17, 2010, 05:52:13 AM
  Did you lightly stain this one? 
Gary

 It has AF on it. The more I look at it the more I think I will scrape it back and do it again, looks like there was oil, probably a thumb print on it.

 Tim C.
Logged
Pages: [1]   Go Up
« previous next »