« previous next »
Pages: [1]   Go Down

Author Topic: Heat treater  (Read 2646 times)

Offline longcruise

  • Hero Member
  • *****
  • Posts: 1839
  • Arvada, Colorado
Heat treater
« on: March 01, 2010, 07:55:21 PM »
Here is something that might be of interest to metal workers or those who aspire.  Myself, I have place to put this.

http://www.govliquidation.com/auction/view?auctionId=3085943&convertTo=USD
Logged
Mike Lee

Offline FALout

  • Hero Member
  • *****
  • Posts: 875
Re: Heat treater
« Reply #1 on: March 05, 2010, 02:31:31 AM »
That one is pretty big for the hobbist, it would do the job tho.  Shipping might get a little expensive if you buy it.
Logged
Bob

omark

  • Guest
Re: Heat treater
« Reply #2 on: March 06, 2010, 08:41:22 AM »
noticed its 3 phase, not many of us will have that available.  mark
Logged

Offline Pete Allan

  • Hero Member
  • *****
  • Posts: 1301
Re: Heat treater
« Reply #3 on: March 06, 2010, 06:30:13 PM »
3 phase is not a problem. If you have 240 single phase you can make a roto phase converter for about $25 to $30 this includes the capasitors to balance the phases. The one I built cost about $30 total and I run my large laths and my mills with no problen. The internet is full of diagrams on how to build them -- very simple ;D
Logged

omark

  • Guest
Re: Heat treater
« Reply #4 on: March 06, 2010, 06:32:49 PM »
didnt know about that, thank you very much.  mark
Logged
Pages: [1]   Go Up
« previous next »