« previous next »
Pages: [1]   Go Down

Author Topic: Small Siler Flint Size ?  (Read 2933 times)

Muleskinner

  • Guest
Small Siler Flint Size ?
« on: July 12, 2010, 01:18:48 PM »
What the best size flint for a small Siler lock ?
Logged

Offline Old Ford2

  • Hero Member
  • *****
  • Posts: 1102
Re: Small Siler Flint Size ?
« Reply #1 on: July 12, 2010, 02:11:54 PM »
Good question!
How wide is the frizzen?
In the fire position, how far from the tip of the cock to the frizzen?
That would be the miximum length of your flint.
Old Ford
Logged
Never surrender, always take a few with you.
Let the Lord pick the good from the bad!

Offline SCLoyalist

  • Hero Member
  • *****
  • Posts: 697
Re: Small Siler Flint Size ?
« Reply #2 on: July 12, 2010, 03:15:41 PM »
Muleskinner, The usual size used, and that recommended  by Chambers Locks on their website, is 5/8W X 3/4 long. 

If that size doesn't give you satisfactory performance, a follow-on post with details of what's not working, like poor sparking or frizzen not flipping open, etc,  would likely get some suggestions on how to correct.
Logged

Offline rich pierce

  • Administrator
  • Hero Member
  • *
  • Posts: 19523
Re: Small Siler Flint Size ?
« Reply #3 on: July 12, 2010, 04:00:24 PM »
5/8 x 3/4 is what most use, as stated above.  If an early small Siler with the older tumbler notches, you may need a shorter flint.
Logged
Andover, Vermont

bchannell

  • Guest
Re: Small Siler Flint Size ?
« Reply #4 on: July 13, 2010, 01:16:41 AM »
Mine uses 5/8" square flints. Is there a kit to upgrade/change to the 5/8"X3/4"? Mine works great, so I'm not sure I'd change it, but I was wondering.
Logged
Pages: [1]   Go Up
« previous next »