« previous next »
Pages: [1]   Go Down

Author Topic: Inletting an Early Ketland  (Read 2246 times)

billd

  • Guest
Inletting an Early Ketland
« on: August 22, 2010, 01:41:56 AM »
An early Ketland has a flat lock plate, no chamfer around it.  Should this be inlet flush with the wood or left to stand proud?  If proud, how much and should I file a chamfer?

Thanks,
BIll
Logged

Offline Tom Currie

  • Hero Member
  • *****
  • Posts: 1294
Re: Inletting an Early Ketland
« Reply #1 on: August 22, 2010, 02:42:33 AM »
I let mine stand proud a bit. Flush inlayed locks are usually a percussion thing and I dont think it would look right on this early lock.

You could always customize it a bit and file a chamfer on it.
Logged

Offline Dennis Glazener

  • Administrator
  • Hero Member
  • *
  • Posts: 19487
    • GillespieRifles
Re: Inletting an Early Ketland
« Reply #2 on: August 22, 2010, 02:43:00 AM »
I do mine flush with the wood or either I file a chamfer around the edges and inlet to the start of the chamfer. The one original that I have seen with an Early Ketland was flush with the wood (or probably was before shrinkage).
Dennis
Logged
"I never considered a difference of opinion in politics, in religion, in philosophy, as cause for withdrawing from a friend" - Thomas Jefferson
Pages: [1]   Go Up
« previous next »