« previous next »
Pages: [1]   Go Down

Author Topic: Making a sheet metal half stock nose cap.  (Read 1839 times)

Offline Roger B

  • Hero Member
  • *****
  • Posts: 1644
  • You wouldn't have a snack, would you?
Making a sheet metal half stock nose cap.
« on: May 26, 2011, 02:53:42 AM »
I understand how to make a full stock cap from tutorials, but how do you fabricate the indented flats on either side of a Hawken cap?
Roger B.
Logged
Never underestimate the sheer destructive power of a minimally skilled, but highly motivated man with tools.

coutios

  • Guest
Re: Making a sheet metal half stock nose cap.
« Reply #1 on: May 26, 2011, 04:06:03 AM »
 I think H House shows that process in his tape about building Hawken rifles...

Regards
Dave
Logged
Pages: [1]   Go Up
« previous next »