« previous next »
Pages: [1]   Go Down

Author Topic: machinist needed  (Read 2307 times)

Offline wvmtnman

  • Hero Member
  • *****
  • Posts: 548
machinist needed
« on: January 27, 2012, 02:20:56 AM »
   I am looking for someone to install a patent breech on a rifle barrel.  The barrel is already fitted to the stock.  I am basically looking for a “drop in” job.  I know that I will need to do a little work but I don’t want to shorten the stock or move the lock.  Does anyone here  know of anyone who is able to do this?
                                                                       Thanks, Brian 
Logged
B. Lakatos

Offline John Archer

  • Sr. Member
  • ****
  • Posts: 364
  • I solemnly swear that I am up to no good
Re: machinist needed
« Reply #1 on: January 27, 2012, 03:36:16 AM »
Dennis McCandless
2094 Tres Pinos Lane
Las Cruces, NM 88005
(575) 382-1978
Call during normal business hours, mountain time

Dennis can handle this for you.

John
Logged
I cannot be left unsupervised.
(Sent from my immobile dial-operated telephone)

Offline wvmtnman

  • Hero Member
  • *****
  • Posts: 548
Re: machinist needed
« Reply #2 on: January 27, 2012, 04:00:15 AM »
Thank You.  I also had some PM's with the same name. 
                                                  Brian
Logged
B. Lakatos

Offline wvmtnman

  • Hero Member
  • *****
  • Posts: 548
Re: machinist needed
« Reply #3 on: January 27, 2012, 04:20:18 AM »
I just got off the phone with him.  I am sending him a rifle to fix.  (the one I posted about a couple weeks ago)  I personally felt, as did Dennis, that the fix would have held with with shooting 25 gr of ffg but if someone else decided to shoot 50 gr of ffg, the drum may blow off.
   Either way, I have decided to sell the rifle and wanted to have it fixed to reduce my risks of being sued.  Better safe than sorry.
                                             Thanks again to all the advice, Brian
Logged
B. Lakatos
Pages: [1]   Go Up
« previous next »