Author Topic: Ambrose Lawing on contemporary makers blog  (Read 2671 times)

Offline RAT

  • Hero Member
  • *****
  • Posts: 699
Ambrose Lawing on contemporary makers blog
« on: April 17, 2013, 04:54:02 PM »
I have a question about the Ambrose Lawing rifle that was posted to the blog. The tang appears to be in 2 pieces... well... actually 3 with the break through the screw hole. This would be a lot easier to make than a very long over-the-comb 1 piece tang. Is this common, or were most done as 1 piece? Is this something unique to this maker?
Bob

Offline Ken G

  • Hero Member
  • *****
  • Posts: 5526
  • F & AM #758
Re: Ambrose Lawing on contemporary makers blog
« Reply #1 on: April 17, 2013, 05:14:39 PM »
My opinion is that it is broken in 2 places.  They are normally one piece.  I have never seen an original intentionally made in 2 pieces.
Cheers,
Ken
Failure only comes when you stop trying.

Offline WElliott

  • member 2
  • Hero Member
  • ****
  • Posts: 593
Re: Ambrose Lawing on contemporary makers blog
« Reply #2 on: April 18, 2013, 05:02:20 AM »
I concur with Ken.
Wayne Elliott

Offline Sequatchie Rifle

  • Global Moderator
  • Hero Member
  • *
  • Posts: 978
  • F. & A.M. Helion #1; 3rd SFG(ABN)
Re: Ambrose Lawing on contemporary makers blog
« Reply #3 on: April 18, 2013, 05:51:14 AM »
My Lawing has the same tang- the one on the blog is broken.
"We fight not for glory, nor riches nor honors, but for freedom alone, which no good man gives up except with his life.” Declaration of Arbroath, 1320