« previous next »
Pages: [1]   Go Down

Author Topic: Hammer Engraving  (Read 2429 times)

idahjo

  • Guest
Hammer Engraving
« on: January 21, 2015, 02:31:29 AM »
Anyone have any experience hammer engraving 7075 Aluminum?
Thanks
Logged

Offline David Rase

  • Hero Member
  • *****
  • Posts: 4320
  • If we need it here, make it here. Charlie Daniels
Re: Hammer Engraving
« Reply #1 on: January 21, 2015, 03:00:12 AM »
I have never engraved 7075 aluminum but I would think since it has average-to-good ratings for machinability and the Rockwell hardness is just slightly higher (3 points) than 12L14 that it would engrave similar to 12L14.  All you can do is grab a piece of scrap and give it a whirl.  :D
David
Logged

Offline Acer Saccharum

  • Hero Member
  • *****
  • Posts: 19311
    • Thomas A Curran
Re: Hammer Engraving
« Reply #2 on: January 21, 2015, 04:42:30 PM »
You'll get a lot more traction on these sites: http://www.engraverscafe.com/  or here: http://www.engravingforum.com/

We hardly know how to engrave over here, much less on aluminum.  :D
Logged
Tom Curran's web site : http://monstermachineshop.net
Ramrod scrapers are all sold out.
Pages: [1]   Go Up
« previous next »