« previous next »
Pages: [1]   Go Down

Author Topic: Barrel Maker Identification?  (Read 1674 times)

Offline Jerry V Lape

  • Hero Member
  • *****
  • Posts: 3028
Barrel Maker Identification?
« on: August 11, 2016, 08:51:52 AM »
I bought a barrel that has been unused for something over 10 years.  Can't find any marks on it except the caliber and twist are stamped on the face of the muzzle.  Square bottom rifling 8 grooves.  Barrel is .50cal 66 in twist.  I am hoping the unusual stamping of caliber and twist on the face of the muzzle is typical of a specific builder?
Logged

Offline smylee grouch

  • Hero Member
  • *****
  • Posts: 7910
Re: Barrel Maker Identification?
« Reply #1 on: August 11, 2016, 02:46:40 PM »
Are the cutts wider than the lands?
Logged

Offline bob in the woods

  • Hero Member
  • *****
  • Posts: 4555
Re: Barrel Maker Identification?
« Reply #2 on: August 11, 2016, 02:52:00 PM »
Douglas used to stamp the cal. and the twist on the face of the muzzle.
Logged

Offline Jerry V Lape

  • Hero Member
  • *****
  • Posts: 3028
Re: Barrel Maker Identification?
« Reply #3 on: August 11, 2016, 06:54:52 PM »
The lands are twice the width of the grooves and I forgot to mention the  barrel is swamped.
Logged

Offline smylee grouch

  • Hero Member
  • *****
  • Posts: 7910
Re: Barrel Maker Identification?
« Reply #4 on: August 11, 2016, 07:20:39 PM »
IIRC Douglas had narrow cuts and wide lands and I think a 1-66 twist. I don't know about a swamped profile though.
Logged
Pages: [1]   Go Up
« previous next »