« previous next »
Pages: [1]   Go Down

Author Topic: Using LMF Stains  (Read 1510 times)

Offline Nhgrants

  • Sr. Member
  • ****
  • Posts: 255
Using LMF Stains
« on: June 15, 2019, 02:10:39 PM »
My plan was to appy diluted cherry to my cherry stock and then apply diluted american walnut over it.
I plan to test this with scraps first.  Do I first put denatured alcohol in a cup and then add the stain to it by
Just drops or much more like teaspoons?  I guess I asking is it just a very little LMF stain added to the denatured   alcohol ?
Thanks
Logged

Offline Mike Brooks

  • Hero Member
  • *****
  • Posts: 13415
    • Mike Brooks Gunmaker
Re: Using LMF Stains
« Reply #1 on: June 15, 2019, 05:14:30 PM »
The few times I used LMF I used it straight out of the can.
Logged
NEW WEBSITE! www.mikebrooksflintlocks.com
Say, any of you boys smithies? Or, if not smithies per se, were you otherwise trained in the metallurgic arts before straitened circumstances forced you into a life of aimless wanderin'?

Offline smallpatch

  • Hero Member
  • *****
  • Posts: 4107
  • Dane Lund
Re: Using LMF Stains
« Reply #2 on: June 15, 2019, 07:16:55 PM »
The best way is to mix it proportionally, I.e. One to one, one to two, etc.  That way you can duplicate the results on your test strips.
Otherwise, it's just a guess.
Logged
In His grip,

Dane

Offline Frank

  • Hero Member
  • *****
  • Posts: 968
Re: Using LMF Stains
« Reply #3 on: June 15, 2019, 09:32:35 PM »
I always apply full strength because it tends to fade over time.
Logged

Offline flehto

  • Hero Member
  • *****
  • Posts: 3335
Re: Using LMF Stains
« Reply #4 on: June 18, 2019, 06:28:23 PM »
LMF stains are used w/o diluting, except the red.....made the mistake of using it full strength and it was the brightest red I could imagine and was very difficult to tone down. Never again......Fred
Logged

Offline T*O*F

  • Hero Member
  • *****
  • Posts: 5123
Re: Using LMF Stains
« Reply #5 on: June 18, 2019, 07:31:30 PM »
Quote
except the red.....made the mistake of using it full strength and it was the brightest red I could imagine and was very difficult to tone down.
You tone it down by soaking a pad with alcohol and rubbing.  It will pull some of the stain out into the pad.  This is also useful if you have a mottled finish and need to even it out.
Logged
Dave Kanger

If religion is opium for the masses, the internet is a crack, pixel-huffing orgy that deafens the brain, numbs the senses and scrambles our peer list to include every anonymous loser, twisted deviant, and freak as well as people we normally wouldn't give the time of day.
-S.M. Tomlinson

Offline flehto

  • Hero Member
  • *****
  • Posts: 3335
Re: Using LMF Stains
« Reply #6 on: June 19, 2019, 12:28:34 AM »
I did just that numerous times and the red color was very stubborn so finally applied some dark brown LMF, rubbed that out w/ alcohol and it did the job......Fred
Logged
Pages: [1]   Go Up
« previous next »