« previous next »
Pages: 1 [2]   Go Down

Author Topic: JB Weld?  (Read 4718 times)

Offline WadePatton

  • Hero Member
  • *****
  • Posts: 5303
  • Tennessee
Re: JB Weld?
« Reply #25 on: December 02, 2019, 07:06:46 PM »
Quote from: Jim Kibler on December 02, 2019, 06:26:28 PM
I'm not sure if anyone has mentioned it, but one key is to not heat the joint directly.   Heat from the bottom of the barrel so as to not burn up the flux.

Jim

Yes, mass considerations and heat control are vital to all welding/brazing/soldering applications. If you burn the flux, stop- clean it up, and start over.


JB Weld is the duct tape of epoxies (same color too-but for the quick set).  It's best used for small fixes where full disassembly and proper repair can be put off for a bit, never as a fabrication method.
Logged
Hold to the Wind

Offline bob hertrich

  • Full Member
  • ***
  • Posts: 139
Re: JB Weld?
« Reply #26 on: December 02, 2019, 07:54:37 PM »
I have used JB Weld in the past not as good as soldering.
Logged

Offline Daryl

  • Hero Member
  • *****
  • Posts: 15846
Re: JB Weld?
« Reply #27 on: December 02, 2019, 08:45:03 PM »
JB Weld also makes a 1/2 decent bedding material.
Logged
Daryl

"a gun without hammers is like a spaniel without ears" King George V

Offline axelp

  • Hero Member
  • *****
  • Posts: 1547
    • TomBob Outdoors, LLC.
Re: JB Weld?
« Reply #28 on: December 03, 2019, 01:23:06 AM »
I had a kit built by a friend and he tried jb weld... my front lug and my front sight both popped off when shooting it for the first time. Had to take it to a smith and had him do it right.
Logged
Galations 2:20

Offline Dave Tercek

  • Starting Member
  • *
  • Posts: 45
Re: JB Weld?
« Reply #29 on: December 03, 2019, 02:24:07 AM »
There are a lot of guns repaired with JB Weld, when the only goal is to get the gun out of the gun show door.
Logged

Offline kudu

  • Full Member
  • ***
  • Posts: 218
Re: JB Weld?
« Reply #30 on: December 05, 2019, 11:49:49 PM »
where you from someone might be able to help with your soldering  ??? Im in  mid Michigan
Logged

Offline Daryl

  • Hero Member
  • *****
  • Posts: 15846
Re: JB Weld?
« Reply #31 on: December 06, 2019, 04:04:38 AM »
Quote from: Dave Tercek on December 03, 2019, 02:24:07 AM
There are a lot of guns repaired with JB Weld, when the only goal is to get the gun out of the gun show door.

Some people can't solder, either. ;)
Logged
Daryl

"a gun without hammers is like a spaniel without ears" King George V
Pages: 1 [2]   Go Up
« previous next »