« previous next »
Pages: [1]   Go Down

Author Topic: Inletting patchbox hinge question.  (Read 820 times)

Offline Jerry V Lape

  • Hero Member
  • *****
  • Posts: 3028
Inletting patchbox hinge question.
« on: April 10, 2020, 08:55:52 AM »
My previous rifles have been sliding wood covers so inletting the hinge on a brass patch box is new experience.  The ends of the hinge are not right yet so the question is how do you finish the ends so they blend into the wood better.  Is filing an angle on them appropriate or is there another method ? 
Logged

Offline Lucky R A

  • Hero Member
  • *****
  • Posts: 1628
  • In Costume
Re: Inletting patchbox hinge question.
« Reply #1 on: April 10, 2020, 01:35:56 PM »
    Usually the top ends of the hinge roll are given a whack with a hammer to slightly flatten them.  This keeps hinge pins in place and the hinge roll is angled into the stock surface.  Final sanding and finishing helps everything to blend smoothly into the stock surface. 
Ron
Logged
"The highest reward that God gives us for good work is the ability to do better work."  - Elbert Hubbard

Offline Jerry V Lape

  • Hero Member
  • *****
  • Posts: 3028
Re: Inletting patchbox hinge question.
« Reply #2 on: April 11, 2020, 09:16:53 AM »
Okay I whacked her with a hammer and then a little filing to enhance the result.  Looks a lot better. 
Logged
Pages: [1]   Go Up
« previous next »