« previous next »
Pages: [1]   Go Down

Author Topic: Not to steal brass melting Acer?  (Read 2392 times)

Offline David Veith

  • Hero Member
  • *****
  • Posts: 611
    • davids painting
Not to steal brass melting Acer?
« on: November 02, 2009, 10:57:33 PM »
Acer Ya We were trying with two gates at the two pin lugs.  The main one was a sand casting poured copy that had been Shellac out to fill and smooth it out.  This summer when I had to order some other Epoxy For my company. They had a mold making pour able one that I order. At the same time that I have been playing with the last few day.  Seeing I HATE to pay shipping in general.
David Veith
« Last Edit: November 05, 2009, 05:32:17 PM by David Veith »
Logged
David Veith

Offline Acer Saccharum

  • Hero Member
  • *****
  • Posts: 19311
    • Thomas A Curran
Re: Not to steal brass melting
« Reply #1 on: November 03, 2009, 04:01:25 PM »
David, I have made rubber molds off original parts, and then made waxes from these molds.
Logged
Tom Curran's web site : http://monstermachineshop.net
Ramrod scrapers are all sold out.

Offline David Veith

  • Hero Member
  • *****
  • Posts: 611
    • davids painting
Re: Not to steal brass melting
« Reply #2 on: November 03, 2009, 04:24:16 PM »
That is the plan. See it is getting a little cooler I may take them over to the ART museum and try pouring them there. Plus I don't own any Investment plaster and can use theres. ;)
David
Logged
David Veith

Offline David Veith

  • Hero Member
  • *****
  • Posts: 611
    • davids painting
Re: Not to steal brass melting Acer ?
« Reply #3 on: November 05, 2009, 05:31:36 PM »
Acer Who's rubber did you use. Seeing I don't Think this product is going to work.
David
Logged
David Veith
Pages: [1]   Go Up
« previous next »