« previous next »
Pages: [1]   Go Down

Author Topic: speaking of ram rod grooves  (Read 870 times)

Offline yip

  • Hero Member
  • *****
  • Posts: 1050
speaking of ram rod grooves
« on: January 30, 2024, 07:45:06 PM »
  stupid question should r/r/ groove run parallel to the bore of the barrel?
« Last Edit: January 31, 2024, 10:04:26 PM by yip »
Logged

Offline Jim Kibler

  • Hero Member
  • *****
  • Posts: 4473
    • Personal Website
Re: speaking of ram grooves
« Reply #1 on: January 30, 2024, 07:49:36 PM »
It can, but certainly doesn't have to.  It can be at an angle relative to the bore and also follow the swamp of the barrel.  Lots of choices to create different results.

Jim
Logged

Offline KShatwell

  • Starting Member
  • *
  • Posts: 23
Re: speaking of ram grooves
« Reply #2 on: January 31, 2024, 07:42:52 PM »
If the forestock is shaped following the swamp of the barrel; does the moulding then follow the swamp or does it remain parallel to the top or the forestock?
Logged

Offline Jim Kibler

  • Hero Member
  • *****
  • Posts: 4473
    • Personal Website
Re: speaking of ram rod grooves
« Reply #3 on: February 01, 2024, 05:02:35 PM »
If the groove follows the gentle barrel swamp, the molding would most likely do the same. 
Logged
Pages: [1]   Go Up
« previous next »