« previous next »
Pages: [1]   Go Down

Author Topic: Front sight dovetail  (Read 3181 times)

LURCHWV@BJS

  • Guest
Front sight dovetail
« on: August 21, 2010, 03:25:06 PM »
  The barrel of my first build has a sight dovetail already cut,  it's a half inch wide.  I can only find 3/8 dovetail sights.  Any suggestions?


   Rich
Logged

Offline Rolf

  • Hero Member
  • *****
  • Posts: 1738
  • There's more than one way to skin a cat.
Re: Front sight dovetail
« Reply #1 on: August 21, 2010, 03:41:41 PM »
Front sights are easy to make. Make a base that fits from a piece of brass sheet metal and silver solder on a blade.

Best regards

Rolfkt
Logged

Offline Shovelbuck

  • Sr. Member
  • ****
  • Posts: 424
Re: Front sight dovetail
« Reply #2 on: August 21, 2010, 03:44:57 PM »
Not to difficult of project to make. Get yourself a block of steel or brass and after about 6 basic cuts with a hacksaw, file to finish shape.
Logged
I don't hunt the hard way, I hunt a simpler way.

J.D.

  • Guest
Re: Front sight dovetail
« Reply #3 on: August 21, 2010, 05:23:06 PM »
Or just find a piece of 1/16"thick brass of steel, fold into an inverted T, solder, and file away everything that doesn't look like a sight.  ;)

God bless
Logged

northmn

  • Guest
Re: Front sight dovetail
« Reply #4 on: August 21, 2010, 06:05:39 PM »
Quote from: J.D. on August 21, 2010, 05:23:06 PM
Or just find a piece of 1/16"thick brass of steel, fold into an inverted T, solder, and file away everything that doesn't look like a sight.  ;)

God bless

Works for me.

DP
Logged

Dave Dolliver

  • Guest
Re: Front sight dovetail
« Reply #5 on: August 22, 2010, 01:29:00 AM »
There is a cast front sight with an oversize base for just such an application.  I got mine from TOW to keep on hand.  But as you can see it isn't hard to make them.

Dave Dolliver
Logged
Pages: [1]   Go Up
« previous next »