Author Topic: Lock work  (Read 12328 times)

Offline Acer Saccharum

  • Hero Member
  • *****
  • Posts: 19311
    • Thomas  A Curran
Re: Lock work
« Reply #25 on: October 28, 2010, 04:19:59 AM »
Thanks, JC, I tempered it from the tail up to the mid-pan cover blue, straw from mid-pan to top of frizzen. I hope it doesn't blow apart. I think if I keep using Rich's flints, it may get milled down to nothing after a few thousand shots. ;D
Tom Curran's web site : http://monstermachineshop.net
Ramrod scrapers are all sold out.

Offline rich pierce

  • Administrator
  • Hero Member
  • *
  • Posts: 19538
Re: Lock work
« Reply #26 on: October 28, 2010, 04:49:15 AM »
Sparks in the pan are better than a thick frizzen.  ;D

Back to the original- maybe show some shots of your bench copy, Tom?  A plain Rev War period rifle, very curly maple, spliced repaired buttstock, cheekpiece shaped like the Brass Barreled rifle, dolphin nosed comb, sideplate like RCA 124 Virginia rifle, tang carving like a Reading rifle, sliding wooden patchbox with resdue in the cavity, .54 caliber swamped barrel, that fine lock, buttplate with little curvature, no restoration done or needed.  Expertly shaped by a bold hand.  Would have been a cool rifle for RCA volume 2 IMHO as it is a real character piece, but it is almost undecorated, and unknown.
Andover, Vermont

Offline Acer Saccharum

  • Hero Member
  • *****
  • Posts: 19311
    • Thomas  A Curran
Re: Lock work
« Reply #27 on: October 28, 2010, 02:37:52 PM »
Here are some photos of the original.




Tom Curran's web site : http://monstermachineshop.net
Ramrod scrapers are all sold out.

Offline Acer Saccharum

  • Hero Member
  • *****
  • Posts: 19311
    • Thomas  A Curran
Re: Lock work
« Reply #28 on: October 28, 2010, 05:08:58 PM »
And then some copy alongside original. My gun is at the stage where I thought I'd better go compare my work with the original. I took a lot more wood off after this session.





« Last Edit: October 28, 2010, 05:10:27 PM by Acer Saccharum »
Tom Curran's web site : http://monstermachineshop.net
Ramrod scrapers are all sold out.