« previous next »
Pages: [1]   Go Down

Author Topic: Question for Mike Brooks about the brass  (Read 2324 times)

Offline Tim Hamblen

  • Starting Member
  • *
  • Posts: 49
Question for Mike Brooks about the brass
« on: November 09, 2012, 02:51:09 PM »
I could have emailed Mike on this but thought others might want to know the answer too. I looked over your tutorial when you built that Carolina gun. The question is, how thick is the brass you use for the trigger guard and buttplate?
Logged

Offline Mike Brooks

  • Hero Member
  • *****
  • Posts: 13415
    • Mike Brooks Gunmaker
Re: Question for Mike Brooks about the brass
« Reply #1 on: November 09, 2012, 04:00:19 PM »
1/16"
Logged
NEW WEBSITE! www.mikebrooksflintlocks.com
Say, any of you boys smithies? Or, if not smithies per se, were you otherwise trained in the metallurgic arts before straitened circumstances forced you into a life of aimless wanderin'?

Offline Tim Hamblen

  • Starting Member
  • *
  • Posts: 49
Re: Question for Mike Brooks about the brass
« Reply #2 on: November 09, 2012, 05:53:27 PM »
Really ? Good to know that, 1/16 I have. I thought it looked closer to 1/8. Thanks Mike.
Logged
Pages: [1]   Go Up
« previous next »