« previous next »
Pages: [1]   Go Down

Author Topic: Engraving Tool question  (Read 3312 times)

Offline tlallijr

  • Full Member
  • ***
  • Posts: 180
Engraving Tool question
« on: February 14, 2014, 08:12:00 PM »
An older thread by Runastav showed a Leman rifle with a "chicken walk" style of engraving on it. http://americanlongrifles.org/forum/index.php?topic=23474.0 I saw a demonstration of how to do this at the Dixon's Muzzleloading fair and would like to know the best type of graver to get to try this. [img][/img]
Logged

Offline T*O*F

  • Hero Member
  • *****
  • Posts: 5122
Re: Engraving Tool question
« Reply #1 on: February 14, 2014, 08:43:30 PM »
It's called wriggle engraving and is done with a flat that is ground to the width you want your lines to be.
Logged
Dave Kanger

If religion is opium for the masses, the internet is a crack, pixel-huffing orgy that deafens the brain, numbs the senses and scrambles our peer list to include every anonymous loser, twisted deviant, and freak as well as people we normally wouldn't give the time of day.
-S.M. Tomlinson

Offline Hungry Horse

  • Hero Member
  • *****
  • Posts: 5565
Re: Engraving Tool question
« Reply #2 on: February 14, 2014, 09:00:54 PM »
 it is the most rudimentary form of engraving, seen on many items for the indian trade. It is done with a graver resembling a small sharpened screwdriver, that is walked along by twisting the wrist.

                               Hungry Horse
Logged

Offline Acer Saccharum

  • Hero Member
  • *****
  • Posts: 19311
    • Thomas A Curran
Re: Engraving Tool question
« Reply #3 on: February 14, 2014, 09:16:47 PM »
Rocking back and forth while twisting a little to advance. Make the tool only as wide as the ribbon you wish to engrave.
Logged
Tom Curran's web site : http://monstermachineshop.net
Ramrod scrapers are all sold out.

Offline Shreckmeister

  • Hero Member
  • *****
  • Posts: 3808
  • GGGG Grandpa Schrecengost Gunsmith/Miller
Re: Engraving Tool question
« Reply #4 on: February 14, 2014, 09:23:19 PM »
Did they tap on it or just push it?
Logged
Rightful liberty is unobstructed action according to our will within limits drawn around us by the equal rights of others. I do not add 'within the limits of the law' because law is often but the tyrant's will, and always so when it violates the rights of the individual.

Offline JTR

  • member 2
  • Hero Member
  • ****
  • Posts: 4351
Re: Engraving Tool question
« Reply #5 on: February 14, 2014, 09:56:58 PM »
Quote from: Shreckmeister on February 14, 2014, 09:23:19 PM
Did they tap on it or just push it?

Push and twist. It's very easy to do, and five minutes practice will make you a pro!
John
Logged
John Robbins
Pages: [1]   Go Up
« previous next »