« previous next »
Pages: 1 [2]   Go Down

Author Topic: Saw in the cheekpiece?  (Read 12450 times)

Offline RobertS

  • Sr. Member
  • ****
  • Posts: 387
Re: Saw in the cheekpiece?
« Reply #25 on: March 03, 2009, 03:17:47 AM »
Here's a company that has quite an assortment of frame saw blades, and the prices seem reasonable.  http://www.traditionalwoodworker.com/default.php/cPath/37_126_571
Logged

Offline Cory Joe Stewart

  • Hero Member
  • *****
  • Posts: 1862
    • My etsy shop
Re: Saw in the cheekpiece?
« Reply #26 on: March 04, 2009, 10:57:39 PM »
Thanks for the images, I am learning a lot from all the images on this forum.

Coryjoe
Logged

Offline Jim Filipski

  • Hero Member
  • *****
  • Posts: 642
    • Jim W. Filipski Flintlocks
Re: Saw in the cheekpiece?
« Reply #27 on: March 05, 2009, 05:51:23 AM »
$#*! you guys are going to laugh!
I use a small hatchet.... on a scratch build I usually know where I want it Just hack it in It'll be pretty close! (Spent too many years fondling a caliper!) Just trust your judgment...bet your close, if not better!
Just my two cents
Jim
Logged
" Associate with men of good quality,  if you esteem your own reputation:
for it is better to be alone than in bad company. "      -   George Washington

"A brush of the hand
of Providence is behind what is done with good heart."
Pages: 1 [2]   Go Up
« previous next »