« previous next »
Pages: [1]   Go Down

Author Topic: Emphasizing moldings  (Read 2735 times)

Offline frogwalking

  • Hero Member
  • *****
  • Posts: 1044
Emphasizing moldings
« on: January 20, 2016, 07:05:58 PM »
I am nearly ready to start finishing the stock on my latest effort.  Even though I bought Jim Kibler's stock carving kit, I have decided not to attempt carving this one.  Everything has gone very well on it to this point and I am afraid to attempt much that may spoil it.  Having said that, my moldings along the forend aligned with every barrel key and ramrod pipe pin (a feat I had previously thought must involve  black magic) and I would like to emphasize this and the lower butt molding.  I have some of Jim Chambers black walnut filler, some Laurel Mountain nut brown and cherry stains.  The stock is a very nicely figured sugar maple which I intend to stain with ferric nitrate.

Thanks,

frog
Logged
Quality, schedule, price; Pick any two.

Online rich pierce

  • Administrator
  • Hero Member
  • *
  • Posts: 19534
Re: Emphasizing moldings
« Reply #1 on: January 20, 2016, 09:21:01 PM »
Time for pictures!
Logged
Andover, Vermont

Offline frogwalking

  • Hero Member
  • *****
  • Posts: 1044
Re: Emphasizing moldings
« Reply #2 on: January 20, 2016, 10:09:15 PM »
I knew you would ask this.


Logged
Quality, schedule, price; Pick any two.

Online rich pierce

  • Administrator
  • Hero Member
  • *
  • Posts: 19534
Re: Emphasizing moldings
« Reply #3 on: January 20, 2016, 10:20:37 PM »
Looking good!
Logged
Andover, Vermont

Offline Acer Saccharum

  • Hero Member
  • *****
  • Posts: 19311
    • Thomas A Curran
Re: Emphasizing moldings
« Reply #4 on: January 21, 2016, 12:51:03 AM »
Sometimes a little relief on one side of the line makes it stand out a LOT.



Logged
Tom Curran's web site : http://monstermachineshop.net
Ramrod scrapers are all sold out.

thimble rig

  • Guest
Re: Emphasizing moldings
« Reply #5 on: January 21, 2016, 01:05:18 AM »
Hey you did all right the moldings.They look good.Oh it is black magic to get those pins and keys lined up right.I always seem to get one off a little.
Logged

Offline frogwalking

  • Hero Member
  • *****
  • Posts: 1044
Re: Emphasizing moldings
« Reply #6 on: January 21, 2016, 04:19:30 AM »
Acer, is that a scraper?  I have a piece of spring stock about that size that would make one.  Is the cutting end bent to 90 degrees, or just rolled over with a burnisher?
Logged
Quality, schedule, price; Pick any two.
Pages: [1]   Go Up
« previous next »