« previous next »
Pages: [1]   Go Down

Author Topic: Patch box lid thickness  (Read 1816 times)

Offline David R. Pennington

  • Hero Member
  • *****
  • Posts: 2930
Patch box lid thickness
« on: May 09, 2016, 08:50:29 PM »
What guage or thickness for an iron box lid. I hammered out a piece of wrought as thin as I could and am filing it down for patchbox lid. I have most the hammer marks filed out on face side and have between about 12 to 14 gauge (slightly tapers). What do you think?
Logged
VITA BREVIS- ARS LONGA

Offline David Rase

  • Hero Member
  • *****
  • Posts: 4333
  • If we need it here, make it here. Charlie Daniels
Re: Patch box lid thickness
« Reply #1 on: May 09, 2016, 09:35:42 PM »
David,
12 to 14 gauge is more than thick enough for steel.  I would not hesitate to thin it down to 18 gauge (.050"). 
David
Logged

Offline Mark Elliott

  • Hero Member
  • *****
  • Posts: 5191
    • Mark Elliott Artist & Craftsman
Re: Patch box lid thickness
« Reply #2 on: May 10, 2016, 12:41:34 AM »
I use 16ga steel sheet for my iron/steel patchboxes.   That is more that thick enough.   I use 1/16" thick brass for a brass box.
Logged
Pages: [1]   Go Up
« previous next »