« previous next »
Pages: [1]   Go Down

Author Topic: bending a trigger guard  (Read 2835 times)

Offline hortonstn

  • Hero Member
  • *****
  • Posts: 653
bending a trigger guard
« on: May 16, 2016, 12:54:41 AM »
I know this has has been discussed until your tired of hearing about it
I have a dst davis double set trigger #6 I need to bend the bar
can I heat it to red without triggers in bar and bend with out breaking
tried once without heating and yes it broke I know not to bend around trigger adjustment screw
thanks?
« Last Edit: May 16, 2016, 01:53:47 AM by Ky-Flinter »
Logged

Offline Bob Roller

  • Hero Member
  • *****
  • Posts: 9694
Re: bending a trigger guard
« Reply #1 on: May 16, 2016, 01:31:42 AM »
Quote from: hortonstn on May 16, 2016, 12:54:41 AM
I know this has has been discussed until your tired of hearing about it
I have a dst davis double set trigger #6 I need to bend the bar
can I heat it to red without triggers in bar and bend with out breaking
tried once without heading and yes it broke I know not to bend around trigger adjustment screw
thanks?

Be sure to reinstall the pivot pins before you try to bend it and the same for the'
adjustment screw.

Bob Roller
Logged

Offline Mike Brooks

  • Hero Member
  • *****
  • Posts: 13415
    • Mike Brooks Gunmaker
Re: bending a trigger guard
« Reply #2 on: May 16, 2016, 04:11:57 AM »
I bend cold. 'course I live close to the edge.
Logged
NEW WEBSITE! www.mikebrooksflintlocks.com
Say, any of you boys smithies? Or, if not smithies per se, were you otherwise trained in the metallurgic arts before straitened circumstances forced you into a life of aimless wanderin'?

Offline Pete G.

  • Hero Member
  • *****
  • Posts: 2013
Re: bending a trigger guard
« Reply #3 on: May 16, 2016, 04:21:12 AM »
Yes you can heat and bend. It is not a hardened part.
Logged

Offline D. Taylor Sapergia

  • Member 3
  • Hero Member
  • *
  • Posts: 12671
Re: bending a trigger guard
« Reply #4 on: May 16, 2016, 07:15:20 AM »
Use three rods in your vise to bend the plate where you want it.
Logged
D. Taylor Sapergia
www.sapergia.blogspot.com

Art is not an object.  It is the excitement inspired by the object.

Offline B Shipman

  • Hero Member
  • *****
  • Posts: 1928
    • W.G. Shipman Gunmaker
Re: bending a trigger guard
« Reply #5 on: May 16, 2016, 07:48:32 AM »
no person, unless they unleash the power of Thor, has ever broken a Davis trigger guard. Put it between two objects and lightly pound on it until you have it. And pound it back if you go to far. Nothing else is required IMHO.
Logged
Pages: [1]   Go Up
« previous next »