« previous next »
Pages: [1]   Go Down

Author Topic: Changing LOP?  (Read 1498 times)

Offline SingleMalt

  • Hero Member
  • *****
  • Posts: 613
  • One day I'll be considered a good builder.
Changing LOP?
« on: February 07, 2017, 06:22:55 PM »
I'd like to lengthen the LOP on an upcoming rifle. How can I do that without making the stock look out of proportion in the wrist area?
Logged
Never drink whisky that isn't old enough to vote.

"The penalty good men pay for indifference to public affairs is to be ruled by evil men."- Plato

"The Constitution shall never be construed to prevent the people of the United States who are peaceable citizens from keeping their own arms."

Offline smylee grouch

  • Hero Member
  • *****
  • Posts: 7907
Re: Changing LOP?
« Reply #1 on: February 07, 2017, 07:58:43 PM »
I need to do that in the other direction on my current project. It ended up a little too long and now if I move it forward,as the butt stock is shaped,I will be moving the butt plate past the end of the stock. I will have to file some of the butt plate off so it doesn't hang below the edge of the stock.  I assume your stock isn't shaped yet Single Malt. Could you just redraw the pattern on the stock to make it fit and look OK.
Logged

Offline SingleMalt

  • Hero Member
  • *****
  • Posts: 613
  • One day I'll be considered a good builder.
Re: Changing LOP?
« Reply #2 on: February 07, 2017, 08:13:56 PM »
Not even cut. Planning ahead.
Logged
Never drink whisky that isn't old enough to vote.

"The penalty good men pay for indifference to public affairs is to be ruled by evil men."- Plato

"The Constitution shall never be construed to prevent the people of the United States who are peaceable citizens from keeping their own arms."
Pages: [1]   Go Up
« previous next »