« previous next »
Pages: [1]   Go Down

Author Topic: Forged Antler Tine Patch Knife  (Read 2029 times)

Offline tippit

  • Sr. Member
  • ****
  • Posts: 377
Forged Antler Tine Patch Knife
« on: August 26, 2017, 12:02:15 AM »
Last knife picture been taking up too much space.  Forged this afternoon an antler tine patch knife.  Blade is three inches...tippit

Logged

Offline rich pierce

  • Administrator
  • Hero Member
  • *
  • Posts: 19538
Re: Forged Antler Tine Patch Knife
« Reply #1 on: August 26, 2017, 03:02:44 AM »
Classy looking, well made, but a 1970's blade design I think.
Logged
Andover, Vermont

Online Jerry

  • Hero Member
  • *****
  • Posts: 562
Re: Forged Antler Tine Patch Knife
« Reply #2 on: August 26, 2017, 04:00:53 AM »
Good looking knife. I like the shape of the blade. Just enough knife. What did you forge the blade from?
Logged

Offline tippit

  • Sr. Member
  • ****
  • Posts: 377
Re: Forged Antler Tine Patch Knife
« Reply #3 on: August 26, 2017, 04:45:02 AM »
Blade forged from 2 1/2 inch scrap of 1084 1X3/8" bar stock.
Logged
Pages: [1]   Go Up
« previous next »