« previous next »
Pages: [1]   Go Down

Author Topic: Baker Rifle powder horn info  (Read 2385 times)

Offline SHARPS4953

  • Starting Member
  • *
  • Posts: 38
Baker Rifle powder horn info
« on: November 10, 2017, 05:48:49 AM »
Greetings, I purchased powder horn castings from the TRS for my Baker rifle and im not sure how the spout is suppose to work. All the castings are brass with a steel casting shaped like a lolly pop, I assume this is a spring that somehow hold the measure in. How is the spring suppose to attach. Has anyone had any experience with this type of measure.
Thanks  Scott
Logged

Offline TN Longhunter

  • Sr. Member
  • ****
  • Posts: 287
Re: Baker Rifle powder horn info
« Reply #1 on: November 10, 2017, 07:48:15 PM »
I have one that I got in a trade but never looked at it that much. Bad news is, it is three states away and I won't be home until Thanksgiving.  If you don't get help before then I'll take mine apart and get some photos for you.
Logged
Don Spires
Tennessee Longhunters
Patron Life NRA
NMLRA
CLA

Offline mark esterly

  • Sr. Member
  • ****
  • Posts: 408
Re: Baker Rifle powder horn info
« Reply #2 on: November 11, 2017, 01:45:08 AM »
Logged
living in the hope of HIS coming.......

Offline SHARPS4953

  • Starting Member
  • *
  • Posts: 38
Re: Baker Rifle powder horn info
« Reply #3 on: November 11, 2017, 03:09:41 AM »
Quote from: TN Longhunter on November 10, 2017, 07:48:15 PM
I have one that I got in a trade but never looked at it that much. Bad news is, it is three states away and I won't be home until Thanksgiving.  If you don't get help before then I'll take mine apart and get some photos for you.

Thanks Sir, no rush. I think I have it figured out. I guess the spring holds the measure in by friction. I was just wondering if they held the spring on with a rivet or screw.  Thanks
Logged
Pages: [1]   Go Up
« previous next »